<?xml version="1.0" encoding="gbk"?>
<rss version="2.0">
<channel>
 <title><![CDATA[系统启动不进入Qtopia]]></title>
 <link><![CDATA[http://www.aiothome.net/read.php?tid=1979]]></link>
 <description><![CDATA[Latest 20 replies of 系统启动不进入Qtopia]]></description>
 <copyright><![CDATA[Copyright(C) ]]></copyright>
 <generator><![CDATA[PHPWind Forums by PHPWind Studio]]></generator>
 <lastBuildDate><![CDATA[Mon, 27 Jul 2026 12:36:09 +0000]]></lastBuildDate>
  <image>
 <url><![CDATA[images/rss.gif]]></url>
 <title><![CDATA[PHPWind Board]]></title>
 <link><![CDATA[http://www.aiothome.net]]></link>
 <description><![CDATA[]]></description>
  </image>
<item>
 <title><![CDATA[]]></title>
 <description><![CDATA[谢谢，问题解决了。
这是我搜到的方法，跟版主说的一样
Origin of question: 
When porting linux in imx27ads, uart serial port is usually used as console. I would like to know if I can have kernel booting message output on both of serial console and framebuffer console or switch from serial console to  ..]]></description>
 <link><![CDATA[http://www.aiothome.net/read.php?tid=1979#6022]]></link>
 <author><![CDATA[crespo1861]]></author>
 <category><![CDATA[Linux技术交流区]]></category>
 <pubdate><![CDATA[Sun, 24 May 2009 12:33:25 +0000]]></pubdate>
</item>
<item>
 <title><![CDATA[]]></title>
 <description><![CDATA[如果你要系统不启动Qtopia，删掉&quot;/bin/qtopia &amp;&quot;这一行就可以了。
至于要使原来打印的串口的信息同时输出到开发板的LCD上，可以试试把内核命令行改成&quot;console=ttySAC0 console=tty0&quot;这样内核的信息会同时输出到串口和LCD上，前提是要内核配置要enable framebuffer console （fbcon）]]></description>
 <link><![CDATA[http://www.aiothome.net/read.php?tid=1979#6006]]></link>
 <author><![CDATA[kasim]]></author>
 <category><![CDATA[Linux技术交流区]]></category>
 <pubdate><![CDATA[Sun, 24 May 2009 09:00:23 +0000]]></pubdate>
</item>
</channel></rss>