lq104vldg52 10.4寸屏,WINCE下驱动选用L80,点屏后能亮,左右显示正常,上下错位了大约1/10,最上排的跑最下面去了,请问在驱动中如何调整,
是在下面的参数中调整吗?
#elif defined(LCD_L80)
#define LCD_WIDTH 640
#define LCD_HEIGHT 480
#define LCD_VBPD_VALUE 0x01
#define LCD_VFPD_VALUE 0x01
#define LCD_VSPW_VALUE 0x01
#define LCD_HBPD_VALUE 0x03
#define LCD_HFPD_VALUE 0x03
#define LCD_HSPW_VALUE 0x28
#define LCD_RGB_OUT_MODE DISP_16BIT_RGB565_P
#define LCD_VCLK_POLARITY IVCLK_FALL_EDGE
#define LCD_HSYNC_POLARITY IHSYNC_LOW_ACTIVE
#define LCD_VSYNC_POLARITY IVSYNC_LOW_ACTIVE
#define LCD_VDEN_POLARITY IVDEN_HIGH_ACTIVE
#define LCD_PNR_MODE PNRMODE_RGB_P
#define LCD_VCLK_SOURCE CLKSEL_F_LCDCLK
#define LCD_VCLK_DIRECTION CLKDIR_DIVIDED
#define LCD_FRAME_RATE 20
#define LCD_TFT_CLKVAL 3
[ 此帖被yxwdczh在2011-05-05 08:41重新编辑 ]
